Freestanding Roofedge System FAQ's

Kite's Freestanding Roof Edge Protection System has been developed to safeguard individuals on roofs from potential falls. It is categorised as a solution for environments involving work at heights, such as roof maintenance or regular visits by engineers or staff for various tasks. The system utilises rubber weights connected to galvanised posts via outriggers to establish a base, onto which galvanised tubes are affixed through the roof of the site. Here, we address common queries from our customers to enhance your understanding of the system.

01) What is the optimal installation method for Kite's Freestanding Roof Edge Protection System?

To meet British Standards, our Freestanding Roof Edge Protection System features:

1100mm height, matching the galvanized posts
Horizontal tubes spaced at 500mm intervals
100mm kickplate, unless an existing roof upstand is present
3m post spacing, offering a more cost-effective solution than 2m spans
1200mm outriggers connecting uprights to rubber weights
Double weights at run ends for added stability

02) What standards does Kite's Freestanding Roof Edge Protection System comply with?

The KITE Roof Edge Protection System fully complies with building and health & safety regulations, including:

BS 13700:2021, BS 8180:2011, BS EN 13374:2004, BS 4592-0:2006+A1:2012, BS EN ISO 14122-3:2001+A1:2010
UK HSE Work at Height (Amendment) Regulations 2007
Wind loadings (BS 6399: Part 2:1995)
Exceeds HSE Report No. 15 & HSG33 standards
Designed for durability & long-term compliance in tough environments.

03) Does the system has any sustainable features?

Kite’s Freestanding Roof Edge Protection System enhances safety while promoting sustainability with a counterweight made from recycled plastic. This eco-friendly design reduces environmental impact while maintaining top-tier fall protection.

04) Has Kite's Freestanding Roof Edge system been tested?

The system has undergone testing to meet British standards (BS EN 13700:2021) with a 0.3 KN load. The testing demonstrated no yielding, fracture, or separation under either dry or wet conditions, confirming conformity to BS 13700:2021.

05) How difficult is the installation process?

Installation is straightforward, requiring no special training or drilling. Upon receiving your order, you can request Kite's operation and maintenance manual for a comprehensive understanding of the entire system.

06) Is an up-stand necessary for system installation?

If your roof lacks a minimum 100mm upstand, fitting kick plates at the lower part of the uprights is recommended to enhance protection against falls. The kick plate height should be a minimum of 100 mm.

07) Does the system require drilling?

No, Kite's Freestanding Roof Edge Protection system does not require any drilling on the roof. This not only enhances safety at height but also contributes to the insulation of the roof from external wet factors.

08) What load is the system set up for?

The system is designed and tested for a 0.3 KN load. However, customisation for different working loads, such as 0.7 KN, is possible, with associated calculation fees added to the total cost for bespoke systems.

09) How easy is it to reinstall the system for use in another site?

The system is easily installable and dismantlable, accommodating adaptation to different sites by adjusting dimensions. Parts can be added or removed as needed for compatibility with new sites.

10) Is the system foldable?

While the system itself is not foldable, we can provide foldable heel clamps to convert the system into a foldable configuration if required.

Click here to go to our Freestanding Roof Edge Protection System Page

WANT TO LEARN MORE?

If you can’t find the information you’re looking for, please don’t hesitate to contact our customer support team. We’re here to help!